Error Codes; Slave Not Responding - YASKAWA F7 User Manual

http://www.aotewell.com

Error Codes

The following table shows Modbus communication error codes.
Error
Code
01H
02H
03H
21H
22H
23H
24H

Slave Not Responding

In the following cases, the slave will ignore the write function.
• When a communication error (overrun, framing, parity, or CRC-16) is detected in the command message.
• When the slave address in the command message and the slave address in the Drive do not agree.
• When the data that configures the message and the data time length exceed 24 bits.
• When the command message data length is invalid.
IMPORTANT
Tel: +(86) 755 8660 6182
Function code error
A function code other than 03H, 08H, or 10H has been set by the master.
Invalid register number error
• The register address you are attempting to access is not recorded anywhere.
• With broadcast sending, a start address other than 0000H, 0001H, or 0002H has been set.
Invalid quantity error
• The number of data packets being read or written is outside the range of 1 to 16.
• In write mode, the number of data packets in the message is not No. of packets x 2.
Data setting error
• Upper limit or lower limit error has occurred in the control data or when writing parameters.
• When writing parameters, the parameter setting is invalid.
Write mode error
• Attempting to write parameters to the Drive during run.
• Attempting to write via Enter commands during run.
• Attempting to write parameters other than A1-00 to A1-05, E1-03, or 02-04 when a
CPF03 (defective EEPROM) fault has occurred.
• Attempting to write read-only data.
Writing during main circuit undervoltage (UV) fault
• Writing parameters to the Drive during UV (main circuit undervoltage) alarm.
• Writing via Enter commands during UV (main circuit undervoltage) alarm.
Writing error during parameters processing
Attempting to write parameters while processing parameters in the Drive.
If the slave address specified in the command message is 0, all slaves execute the write function, but do not
return response messages to the master.
Aotewell
Table D.8 Error Codes
Contents
Communications D - 17
Aotewell
Email: Sales@aotewell.com
http://www.aotewell.com