Removing And Mounting The Terminal Card; Terminal Card Removal Procedure - YASKAWA F7 User Manual

http://www.aotewell.com

Removing and Mounting the Terminal Card

The terminal card can be removed and mounted without disconnecting the control wiring.
IMPORTANT
Removing the Terminal Card
1. Remove the terminal cover on the Drive.
2. Remove the Digital Operator and front cover from the Drive.
3. Remove the wires connected to FE and/or NC on the terminal card.
4. Loosen the mounting screws on the left and right sides of the terminal card until they are free. It is not necessary to remove
the mounting screws completely. They are captive and self-rising.
5. Pull the terminal card out in the direction of the block arrow.
Mounting the Terminal Card
Reverse the removal procedure to mount the terminal card.
Confirm that the terminal card and the Control PCB properly meet at connector CN8 before insertion.
The connector pins may be damaged if the terminal card is forced into place, possibly preventing correct Drive operation.
Mounting
Screw
Tel: +(86) 755 8660 6182
Always confirm that input power is removed and the Charge LED is not lit before removing or mounting the terminal
card.
FE NC
Fig 7.3 Terminal Card Removal Procedure
Aotewell
CN8
Maintenance 7 - 7
Aotewell
Email: Sales@aotewell.com
http://www.aotewell.com
Mounting
Screw