Heat Sink Mount Resistor Installation; Attaching Heat Sink Mount Resistor On Heat Sink - YASKAWA F7 User Manual

http://www.aotewell.com

Heat Sink Mount Resistor Installation

1. Remove the Drive from its mounting for access to the rear of the heat sink.
2. Attach the Heat Sink Mount Resistor on the back of the Drive's heat sink with screws M4 x 10mm (0.7mm pitch), as shown
in figure below.
3. Remove the rubber plug and run the braking resistor wires into the hole that leads to the terminal block.
4. Reinstall the Drive in its mounting position.
5. Connect the leads from the Heat Sink Mount Resistor to the Drive terminals B1 and B2.
6. Proceed to "Adjustments" section on page 2-18.
Tel: +(86) 755 8660 6182
Aotewell
Fig 2.5 Attaching Heat Sink Mount Resistor on Heat Sink
Electrical Installation 2 - 13
Aotewell
Email: Sales@aotewell.com
http://www.aotewell.com