Appendix L: Omni-M-Ect4 Module Specifications; Ect Acquisition Module Description; Ect Acquisition Module Receptacles - Olympus OmniScan MX User Manual

Appendix L: OMNI-M-ECT4 Module Specifications

IMPORTANT
The OMNI-M-ECT4 module is compatible with the OmniScan MX only.
This appendix presents eddy current (ECT) acquisition module model
OMNI-M-ECT4, which can be used with the OmniScan MX unit.
L.1

ECT Acquisition Module Description

The OMNI-M-ECT4 acquisition module (See Figure L-1 on page 174) is designed for
durability and simplicity. Any conventional eddy current probe with up to four
channels can be connected to the module.
L.2

ECT Acquisition Module Receptacles

The ECT acquisition module is equipped with two receptacles on the left side.
1CH
BNC receptacle for one single-coil eddy current probe using conventional eddy
current technique.
4CH
A 19-pin receptacle used for eddy current probes with up to four single coils.
DMTA-20015-01EN [U8778402], Rev. M, February 2017
OMNI-M-ECT4 Module Specifications 173