Flashing green
Flashing red
1.1.6.2
Acquisition Indicator Light
The acquisition indicator light is located below the Play key (
light indicates the operating mode of the OmniScan MX2 (see Table 6 on page 29).
Off
Orange
IMPORTANT
The OmniScan MX2 must be turned off before the acquisition module is installed or
removed.
1.1.6.3
Alarm Indicator Lights
There are three alarm indicator lights (numbered 1, 2, and 3) located on the upper
right corner of the OmniScan MX2. These lights only flash one color (red) and indicate
the trigger status of their respective alarms (set within the software).
NOTE
For more details about the alarm indicator lights, refer to the OmniScan MXU Software
User's Manual.
Table 5 Power indicator light statuses (continued)
•
The OmniScan MX2 is in sleep mode.
•
The OmniScan MX2 is in sleep mode and battery
charging is complete.
A critical factor (excessive temperature, very weak
batteries, etc.) requires immediate attention.
Table 6 Acquisition indicator light statuses
Oscilloscope mode acquisition
Freeze analysis mode
DMTA-20015-01EN [U8778402], Rev. M, February 2017
Overview of the Equipment
). The color of this
29