Battery Charging; Figure 2-5 Removing A Lithium-Ion Battery - Olympus OmniScan MX User Manual

DMTA-20015-01EN [U8778402], Rev. M, February 2017
3. Insert a new battery. Make sure that the groove on the battery is aligned with the
small edge inside the battery compartment.
4. Close the battery compartment door.
The batteries are recharged inside the OmniScan MX2 when it is connected to a DC
power adaptor. Connecting an adaptor automatically starts the recharging process.
The batteries can also be recharged using an optional external charger.
2.3.5

Battery Charging

To charge the OmniScan MX2 batteries
 Connect the OmniScan MX2 to a proper DC power adaptor.
Battery charging is performed as follows:
— When the OmniScan MX2 is turned off:
When the OmniScan MX2 is connected to a proper DC power source and is
turned off, it will automatically recharge any battery requiring charging,
starting with the weakest battery (if the recharge conditions are met).
Once the weakest battery has reached the level of the other battery, both
batteries are charged simultaneously.
42 Chapter 2

Figure 2-5 Removing a lithium-ion battery

Battery compartment door
Lithium-ion battery