12. Connector References
WARNING
Always use equipment and accessories that meet Olympus specifications. Using
incompatible equipment can result in a malfunction, equipment damage, or injury.
This chapter provides a technical description of the three OmniScan MX unit
connectors below:
•
"Serial Connector" on page 118 (
•
"Scanner Interface Connector" on page 119 (
•
"Alarm and I/O Connector" on page 122 (
The following information is provided for each of these connectors: a brief
description, the manufacturer's number, the number of the corresponding cable
connector, an illustration, and a table with the signal pinout for the connector.
The following OmniScan MX connectors comply with their respective standards:
•
CompactFlash PCMCIA (memory card slot)
•
Audio output (headphone jacks)
•
Circular DC power jack, 2.5 mm pin diameter, 15 VDC to 18 VDC (polarity:
•
USB
•
Ethernet (RJ-45)
•
VGA
)
DMTA-20015-01EN [U8778402], Rev. M, February 2017
)
)
)
Connector References
117