Battery Removal And Installation; Table 7 Battery Status Indicator Variations - Olympus OmniScan MX User Manual

Indicator
2.3.4

Battery Removal and Installation

To remove or install a battery
1. On the right side panel, turn the two quarter-turn latches to open the battery
compartment door.
2. Pull the cloth tab to remove the battery (see Figure 2-5 on page 42).

Table 7 Battery status indicator variations

Outline Fill
Dotted N/A
Blue Blue
Blue Orange
Yellow Blue
(blinking)
Orange Blue
Red Blue
(blinking)
N/A Yellow
DMTA-20015-01EN [U8778402], Rev. M, February 2017
Meaning
There is no battery in that compartment.
The battery is functioning properly.
The battery is too hot for use.
The battery is charging.
The battery is too hot to be charged, or
the internal system temperature is too
high to enable charging (over 60 °C
[140 °F]).
The battery charge is critically low (less
than 10 %). A beeping noise is emitted
when there is no spare battery available.
The OmniScan MX2 is being powered
externally through the DC adaptor.
Basic Operation 41