9. Maintenance
This chapter describes the basic maintenance that must be performed on the
OmniScan MX unit by operators. The maintenance operations explained below enable
you to keep your instrument in good physical and working condition. By virtue of its
design, the OmniScan MX only requires minimal maintenance. The chapter covers
preventative maintenance and instrument cleaning.
9.1
Preventative Maintenance
The OmniScan MX does not have many moving parts, and therefore only requires
minimal preventative maintenance. Simply perform regular inspections to keep the
OmniScan MX in proper working order.
9.2
Instrument Cleaning
The OmniScan MX external surfaces (which includes the casing, the acquisition
module, and the LCD screen protector) may be cleaned as needed. This section
provides the appropriate procedure for cleaning the instrument.
9.2.1
Casing and Acquisition Module Cleaning
To clean the casing and acquisition module
1.
Make sure that the instrument is turned off, the power cord is disconnected, and
the batteries have been removed.
2.
Disconnect all cables and connectors, and make sure that all external ports on the
OmniScan MX have been covered with their rubber protectors.
DMTA-20015-01EN [U8778402], Rev. M, February 2017
Maintenance
103