Peripheral Connection - Olympus OmniScan MX User Manual

WARNING
• Do not open, crush, or perforate batteries; doing so could cause injury.
• Do not incinerate batteries. Keep batteries away from fire and other sources of
extreme heat. Exposing batteries to extreme heat (over 80 °C [176 °F]) could result
in an explosion or personal injury.
• Do not drop, hit, or otherwise abuse a battery, as doing so could expose the cell
contents, which are corrosive and explosive.
• Do not short-circuit the battery terminals. A short circuit could cause injury and
severe damage to a battery, making it unusable.
• Do not expose a battery to moisture or rain; doing so could cause an electric
shock.
• Only use the OmniScan MX2 or an external charger approved by Olympus to
charge the batteries.
• Do not recharge a battery unless the indicators light up when the capacity check
button on the battery is pressed. Doing so could be dangerous.
• Do not store batteries that have less than 40 % remaining charge. Recharge
batteries from 40 % to 80 % capacity before storing them.
• During storage, keep the battery charged to between 40 % and 80 %.
• Do not leave batteries in the OmniScan MX2 during instrument storage.
2.4

Peripheral Connection

This section explains the peripherals that can be used with the OmniScan MX2.
IMPORTANT
The OmniScan MX2 has been tested and found to comply with the radio-frequency
limits applicable to industrial devices, in accordance with the requirements of the
EMC directive. To maintain OmniScan MX2 compliance with the emissions
requirements of the EMC directive, the following conditions must be met:
• All cables used to connect the equipment must have an overall shielding to ensure
electromagnetic compatibility and optimal performance.
DMTA-20015-01EN [U8778402], Rev. M, February 2017
Basic Operation 45