Verifying The Global Ipv6 Address; Verifying The Switch Ipv6 Default Gateway Configuration - Avaya Virtual Services Platform 7000 Series Troubleshooting Manual

Troubleshooting IPv6
2. Use the show ipv6 interface vlan <vid> command to display the IPv6
3. Observe whether the ADMIN STATE is enabled or disabled.
4. If IPv6 is ADMIN STATE is disabled, use the interface vlan <vid>
5. Use the ipv6 interface enable command to enable IPv6 for the management
6. You can repeat steps 2 and 3 to confirm the change.

Verifying the global IPv6 address

Use this procedure to verify that an IPv6 address is configured for the switch that does not
respond to the ping.
Procedure
1. Use the show ipv6 address <switch | unit> command to display if an IPv6
2. If required, use the ipv6 address {switch | unit} <ipv6_address/
3. You can repeat step 1 to confirm the change.

Verifying the switch IPv6 default gateway configuration

Use this procedure to verify that the switch that does not respond to the ping is configured for
the IPv6 default gateway.
Procedure
1. Use the show ipv6 default-gateway command to display the IPv6 default
2. If required, use the ipv6 default–gateway <ipv6_addr> command to
3. You can repeat step 1 to confirm the change.
44 VSP 7000 Troubleshooting
configuration for the management VLAN.
command to configure the management VLAN.
VLAN.
address is configured for the switch.
prefix_length> command to assign an IPv6 address to the switch.
gateway configuration for the switch.
configure the switch for the IPv6 default gateway.
Comments? infodev@avaya.com
March 2012