Checking An Interface Rip Timeout Interval; Configuring Interface Rip Timeout Interval; Rip Routes Are Learned With Increasing Cost - Avaya Virtual Services Platform 7000 Series Troubleshooting Manual

Troubleshooting Layer 3

Checking an interface RIP timeout interval

Display and observe the RIP timeout interval configured for a VLAN or Ethernet interface.
Procedure
1. Log on to ACLI to enter User EXEC mode.
2. To display RIP configuration information for a specific VLAN, enter the show ip rip
interface vlan <1–4094> command.
3. To display RIP configuration information for RIP–enabled VLANs only, enter the show ip
rip interface vlan enabled command.
4. To display RIP configuration information for one or more specific Ethernet interfaces, enter
the show ip rip interface Ethernet <port_list> command.
5. To display RIP configuration information for RIP–enabled Ethernet interfaces only, enter the
show ip rip interface Ethernet enabled command.
6. Observe and note the interface RIP timeout settings.

Configuring interface RIP timeout interval

Ensure that the RIP timeout interval for a VLAN or Ethernet interface is set to a value greater than
the global RIP update interval.
Procedure
1. Enter Interface Configuration mode:
enable
configure terminal
interface Ethernet <port> or interface vlan <1–4094>
2. Enter the ip rip timeout <15–259200> command.

RIP routes are learned with increasing cost

This section describes the troubleshooting process you can use to diagnose and resolve a situation
where network switches learn advertised RIP routes with an increasing cost metric value.
Troubleshooting Avaya VSP 7000 Series
90
Comments on this document? infodev@avaya.com
July 2015