Cd-Rw/Dvd And Hard Disk Drive Mounting Frame (Serial Number B029999 And Below) 4 - Tektronix DSA8200 Service Manual

CD-RW/DVD and Hard
Disk Drive Mounting
Frame (Serial number
B029999 and below)
DSA8200 Digital Serial Analyzer and Modules Service Manual
CD-RW/DVD drive assembly
CD-RW/DVD drive mounting frame
Figure 4- - 25: Removing the CD-RW/DVD drive from the mounting frame (serial
number B030000 and above)
1. Locate module to be removed: Locate the CD-RW/DVD and hard drive
mounting frame in the locator diagram Internal Modules, Figure 4- -8, page
4- -20. Additional modules to be removed:
Trim (all)
Bottom cover
Left and Right covers
CD-RW/DVD drive
Hard drive
2. Orient the instrument: Set the instrument so its bottom is down on the work
surface and the side with the mounting drive side is facing you.
3. Remove the mounting frame. See Figure 4- -26, page 4- -42.
a. Remove the six T-15 Torxdrive screws that secure the mounting frame to
the ATX chassis.
Removal and Installation Procedures
Small Phillips screw (4)
4- - 41