Table 6 Command output
Field
Flow Statistic Interval
Port
StormType
LowerLimit
UpperLimit
Unit
CtrlMode
Status
Trap
Log
StateChanges
duplex
Use duplex to set the duplex mode for an Ethernet interface.
Use undo duplex to restore the default duplex mode of the Ethernet interface.
Syntax
duplex { auto | full | half }
undo duplex
Default
Ethernet interfaces operate in autonegotiation mode.
Description
Traffic polling interval (in seconds) of the storm control module.
Abbreviated port name.
Type of traffic subjected to storm control:
•
BC—Broadcast packets.
•
MC—Multicast packets.
•
UC—Unknown unicast packets.
Lower storm control threshold, in pps, kbps, or percentage.
Upper storm control threshold, in pps, kbps, or percentage.
Storm control threshold unit:
•
pps.
•
kbps.
•
percentage.
Protective action (block or shutdown) taken on the port when the upper
threshold is reached. N/A indicates that no protective action is configured.
Packet forwarding status:
•
forwarding—The port is forwarding traffic normally.
•
shutdown—The port has been shut down.
•
block—The port drops the type of traffic.
Status of the storm control threshold event trap switch:
•
on—The port sends threshold event traps.
•
off—The port does not send threshold event traps.
Status of the storm control threshold event log switch:
•
on—The port sends threshold event log messages.
•
off—The port does not send threshold event log messages.
Number of forwarding state changes of the interface.
When the StateChanges count reaches 65,535, it resets automatically.
16