Changeover To System Screen; Display Example Of System Screen - Mitsubishi Electric F930GOT-BWD-E User Manual

Graphic Operation Terminal F930GOT
12.5

Changeover to system screen

Function screens built in the GOT such as the HPP MODE screen, the SAMPLING MODE
screen, the ALARM MODE screen and the OTHER MODE screen can be displayed as user
screens.
12.5.1

Display example of system screen

This paragraph describes the method to display a system screen as a user screen (that is, dis-
play a system screen in the screen mode) and the caution on this method.
• A system screen can be displayed by specifying a corresponding screen No. shown in the
next page. In this case, the following setting is required so that the previous user screen can
be displayed after the system screen.
1) When a system screen is displayed as the base screen (from the PLC)
Screen No. 1
Screen No. 1001
[ DEVICE MONITOR screen ]
[ DEVICE MONITOR ]
DEVICE ON
SET
COMMENT
Return to the user screen No. + "END" key
• A sequence program to return to a user screen can be executed at any time while a sys-
tem screen is displayed.
1) When a system screen is displayed using a touch key
• Specify a desired screen No. within the range of Nos. 1001 to 1030 in the same way as
specification of a user screen.
• When the END key provided at the upper right corner of the system screen is pressed,
the previous user screen is automatically displayed again. (That is, the setting to return
to the previous screen is not required.)
END
OFF
DEC/HEX
Creation of Display Screens (SWo o o o D5C-GOTRE-PACK) 12
•When the sequence program shown below is executed
while the screen No. n is displayed, the screen No.
1001 (DEVICE MONITOR screen) is displayed.
-Word device to change over the base screen of the
GOT: D0
-Sequence program
MOV
•To return to the previously displayed user screen from a
system screen, execute a program which specifies the
screen to be returned and press the END key provided
at the upper right corner of the system screen. Then,
the previous user screen is displayed again.
MOV K¡¡¡
The screen No. 1001
K1001 D0
is specified.
D0
Word device for changeover
Screen No. of a screen to be
displayed next (user screen No.).
12-7