Connection Of Peripheral Units Of Plc - Mitsubishi Electric F930GOT-BWD-E User Manual

Graphic Operation Terminal F930GOT
1.5.3

Connection of peripheral units of PLC

When a general-purpose personal computer is directly connected to the GOT, the two-port
interface FX-2PIF (two-port interface function) is not required.
When one GOT and one peripheral unit for sequence program creation are used for one PLC,
the two-port interface FX-2PIF is required. The system configuration required in this case is
shown below.
When the two-port interface FX-2PIF is used
ž
Graphic operation terminal
F930GOT-BWD-E
ž
Two-port
interface
FX-2PIF
Data transfer
cable
FX-422CAB0
ž
FX /FX /FX
0 0S
FX Series
2NC
When the two-port interface function is used, the operation environment should
be set for it.
(Refer to the description on "SERIAL PORT" on the SET-UP MODE screen.)
Data transfer cable FX-232CAB-1 (3 m) (when the RS-232C connector in
the PC is 9-pin type),
Data transfer cable FX-232CAB-2 (3 m)
(when the RS-232C connector in the PC is half-pitch, 14-pin type) or
Data transfer cable F
(when the RS-232C connector in the PC is 25-pin type)
Connection cable FX-40DU-CAB (3 m) or Connection cable FX-40DU-CAB-10M (10 m)
Data transfer cable FX-422CAB (0.3 m) or
Data transfer cable FX-422CAB-150 (1.5 m)
ž
/FX /
FX/FX
0N 2N
2C
Programmable controller
-232CAB-1 (3 m)
2
Program cable FX-20P-CAB (1.5 m)
Data transfer cable AC30R4 (3 m)
ž
A Series (except QnA)
/ Series
(Refer to Paragraph 1.8.)
Motion controller
Introduction 1
1
2
3
1-9