Introduction; Outline - Mitsubishi Electric F930GOT-BWD-E User Manual

Graphic Operation Terminal F930GOT
1.

Introduction

This section describes the product configuration and the system configuration of the graphic
operation terminal. Confirm diversified functions of each unit.
1.1

Outline

The graphic operation terminal (hereafter abbreviated to
"GOT") is to be mounted on the face of a control panel or
operation panel, and connected to the programming con-
nector of an FX or A Series programmable controller (here-
after abbreviated to "PLC").
Various PLC devices can be monitored and the PLC data
can be changed through the screen of the GOT.
There are several display screens built-in to the GOT which
offer various functions. In addition, user-defined screens
can be created.
The user defined-screens (user screens) and the built-in
screens (system screens) have the following respective
functions.
User screens
• Screen display function
User screens can be displayed, and the following functions can be assigned to each screen.
The available screens can be limited using the security function.
Both software packages, FX-PCS-DU/WIN-E (V.2.30 or later) for DU and SW¨D5C-
GOTRE-PACK (V.H or later) ("¨" indicates a numeric not less than "1".) for GOT, can be
used to create user screens.
Display function
1) Up to 500 user screens can be displayed. In screen creation, two or more screens can
be overlaid or changed over arbitrarily.
2) Simple graphics such as straight lines, circles and rectangles can be displayed, along
with numbers, alphabets, Hiragana, Katakana and Kanji characters.
Monitor function
1) Set values and current values of word devices in the PLC can be displayed in numerics
or bar graphs for monitoring.
2) The specified range of the screen components can be displayed in reverse in accor-
dance with the ON/OFF status of bit devices in the PLC.
Data change function
1) The numeric data being monitored can be changed.
Switch function
1) By manipulating the operation keys in the GOT, bit devices in the PLC can be set to ON
and OFF. The display panel face can be assigned as touch keys to offer the switch func-
tion.
Introduction 1
FX or A
Series PLC
Programming
connector
GOT main body
1-1