Mitsubishi Electric F930GOT-BWD-E User Manual page 88

Graphic Operation Terminal F930GOT
2) Screen changeover
If "screen changeover" is selected, when a specified alarm device becomes ON from OFF, a
user screen displayed at that time in the screen mode is changed over to a screen of speci-
fied No. (When the SWoD5C-GOTRE-PACK is used, a screen of specified No. is displayed
when the DETAIL key is pressed.)
The display can be returned from the specified screen to the previous screen using the fol-
lowing procedure.
- In the case of FX-PCS-DU/WIN-E
Set "Destination Screen" to "DU memory" in the "Change Screen" object of the changed-
over screen.
- In the case of SWoD5C-GOTRE-PACK
Set "Destination Screen" to "Upper Hierarchy" in "Change Screen" of the changed-over
base screen.
3) Printing
When an alarm has occurred, the date of occurrence and a corresponding alarm message
can be printed.
Alarm messages should have been entered in half-width characters. The communication
condition of the used printer should have been set in "SERIAL PORT" in "SET-UP MODE" in
the GOT.
4) Flow display (valid when the SWoD5C-GOTRE-PACK is used)
When an alarm device becomes ON, a corresponding alarm message is displayed at the
bottom of the user screen.
Alarm message
It can be set for each screen whether or not the flow display is to be performed by editing
"Common Setting"-"Auxiliary Setting"-"Screen" in the screen creation software. (In the initial
value, the flow display is effective.)
• A message is flown from the right to the left.
• When two or more alarms have occurred, correspond-
ing messages are displayed in the ascending order of
alarm device No.
• When alarm devices become OFF, alarm messages
disappear.
• Alarm messages are displayed transparently on the
user screen, so keys on the user screen are effective.
Alarm Function 7
7-4