Mitsubishi Electric F930GOT-BWD-E User Manual page 261

Graphic Operation Terminal F930GOT
• Setting of computer link unit
Set the communication format of the computer link unit as shown below.
Used port
Mode setting switch No.
Transmission speed
Data bit
Stop bit
Parity bit
Sum check
Write during run
Station No.
• Caution: When RS-232C is connected
The GOT does not control CD signals. Accordingly, when the RS-232C is connected, the
buffer memory in the computer link unit should be set so that CD signals are not checked.
Example: When I/O signals in the computer link unit are 80 (H) to 9F (H)
• Restriction in functions
In connection via a computer link unit, the following functions of the GOT are disabled.
- Index registers (V and Z) cannot be monitored, and their current values cannot be
changed.
- When the RS-232C is connected for communication, the printer output function of the
GOT is disabled.
- The two-port interface function is disabled.
When RS-422 is use
RS-422: Format 5
RS-232C: No-procedure
00 to 0F (in accordance with setting in GOT)
Write to buffer memory
Computer link unit connection point
X87
TO H8 H10B
P
Additional Functions (in V.2.00 or later) 13
When RS-232C is used
5
RS-422: No-procedure
RS-232C: Format 1
19200 bps
8 bits
1 bit
Provided: Odd
Provided
Possible
K1 K1
K1: CD terminal will not be checked.
10B (H): CD terminal will be checked.
1
← The GOT station
No. can be set in
"SET-UP MODE".
13-13