Mitsubishi Electric F930GOT-BWD-E User Manual page 35

Graphic Operation Terminal F930GOT
When the GOT is connected to the SYSMAC C Series PLC manufactured by OMRON, the fol-
lowing setting is required.
• Setting of host link unit
Set the communication format of the host link unit as shown below.
Table 1.5:
Used port
Transmission speed
Data bit
Stop bit
Parity bit
Communication mode
Command level
Procedure
Unit No.
The GOT station No. can be set in "SET-UP MODE". (Refer to Paragraph 2.2.)
Only a model in which these set items are offered can be connected to the GOT.
Setting example:
Set the communication format while referring to setting examples of each C Series host link unit.
In the case of CQM1-CPU : Setting by data memory (DM)
Table 1.6:
Set item
Standard communication con-
dition (RS-232C: DN6645)
Communication condition
(RS-232C: DM6646)
Send delay time
(RS-232C: DM6647)
Unit No. (RS-232C: DM6648)
In the case of host link unit attached to C200H base :
Setting by each switch (when C200H-LK201-V1/C200H-LK202-V1 is used)
- Setting of switches on front face
(common between C200H-LK201-V1 and C200H-LK202-V1)
Table 1.7:
Set item
Unit No.
Transmission speed
Communication condition
*1 Equivalent to station No. setting in the GOT
When RS-422 is used
00 to 15 (BCD) (in accordance with setting in GOT)
↑
Set item
Mode specification: Host link
0001H
Communication condition: In accordance with DM6646
Transmission format: 7 data bits and 2 stop bits
0304H
Parity: Even
0000H
0 second
(initial status)
××: Two-digit BCD (in accordance with setting in GOT)
00××H
Switch setting
SW1 *1
SW2 *1
SW3 6
SW4 2
When RS-232C is used
19200 bps
7 bits
2 bit
Even
Host link mode
Level 1, 2 or 3
1:N procedure
Remarks
Transmission speed: 19,200 bps
Remarks
Upper digit BCD
Lower digit BCD
19200 bps
7 ASCII bits and 2 stop bits
Parity: Even Command level: 1, 2 or 3
Introduction 1
1-21