Hpp Mode; Outline Of Hpp Mode - Mitsubishi Electric F930GOT-BWD-E User Manual

Graphic Operation Terminal F930GOT
4.

HPP Mode

In the HPP mode, devices can be monitored, and set values and current values can be
changed from the GOT to the connected PLC.
4.1

Outline of HPP mode

This paragraph describes the operating procedure to change over to the HPP mode and each
function available in the HPP mode.
u u u u Basic operation
The SELECT MODE
screen is displayed.
Paragraph 2.3
[HPP MODE MENU]
[HPP MODE]
DEVICE MONITOR
ACTIVE STATE MONITOR
PC DIAGNOSIS
• In the case of computer link connection, monitoring and the set value change range are
restricted. For the details, refer to Section 1.
The HPP MODE
HPP MODE
screen is displayed.
Select "HPP
MODE" on
The screen shown
the screen.
below is displayed.
• Among the following functions, 2) and 3) are valid
only when the FX Series PLC is connected.
END
1) DEVICE MONITOR (Paragraph 4.2)
1)
The ON/OFF status and the set value/current
2)
value of arbitrary devices in the PLC can be
3)
monitored. In addition, the ON/OFF status can
be forcedly set to ON/OFF and the set values/
current values can be changed.
2) ACTIVE STATE MONITOR (Paragraph 4.3)
The state (S) Nos. in the ON status in the FX
Series PLC are displayed.
3) PC DIAGNOSIS (Paragraph 4.4)
The error information of the FX Series PLC is
displayed.
HPP Mode 4
4-1