Setting Of System Information (Control Devices) - Mitsubishi Electric F930GOT-BWD-E User Manual

Graphic Operation Terminal F930GOT
13.2.3

Setting of system information (control devices)

When a bar code reader is connected, the system information (control devices) are required to
be set.
Set the system information in "Common Setting" in the screen creation software.
Bar code input
Bar code input invalid
Bar code input read completed b6 of "head read device"
- Bar code input (GOT → PLC)
Because this signal becomes ON when the data read by the bar code reader is stored in
the PLC, the write timing can be confirmed using this signal.
To set to OFF this bar code input signal, set to ON the bar code input read completed
signal.
- Bar code input read completed (PLC → GOT)
This signal sets the bar code input signal from ON to OFF.
- Bar code input invalid (PLC → GOT)
When this bit is set to ON when a bar code is connected, the bar code input becomes
invalid.
The data read by the GOT is cleared.
Bar code input (GOT → PLC)
Bar code input read completed
(PLC → GOT)
• In the following condition, the data read by the bar code reader is not written to the PLC.
When the bar code input invalid signal is ON
When the bar code input read completed signal remains ON
When the bar code input signal is ON
System information
SWo o o o D5C-GOTR-PACK
b5 of "head write device +4"
b5 of "head read device"
Refer to Paragraph 8.6.2.
Data is read.
Data is written to PLC.
Additional Functions (in V.2.00 or later) 13
Control device
FX-PCS-DU/WIN-E
M¡ + 8
M¡ + 9
M¡ + 10
Refer to Paragraph 8.6.1.
(Refer to next
paragraph.)
13-3