Settings - ABB REL650 Technical Manual

1MRK 506 382-UEN A
19.2.4
Table 604: SETGRPS Non group settings (basic)
Name Values (Range)
ActiveSetGrp
MaxNoSetGrp
19.2.5
Line distance protection REL650 2.2 IEC
Technical manual
Table 603: ACTVGRP Output signals
Name
GRP1
GRP2
GRP3
GRP4
GRP5
GRP6
SETCHGD
REMSETEN

Settings

Unit
SettingGroup1 -
SettingGroup2
SettingGroup3
SettingGroup4
SettingGroup5
SettingGroup6
1 - 6 -
Operation principle
Parameter setting groups ActiveGroup function has six functional inputs, each
corresponding to one of the setting groups stored in the IED. Activation of any of
these inputs changes the active setting group. Eight functional output signals are
available for configuration purposes, so that information on the active setting group
is always available.
A setting group is selected by using the local HMI, from a front connected personal
computer, remotely from the station control or station monitoring system or by
activating the corresponding input to the ActiveGroup function block.
Each input of the function block can be configured to connect to any of the binary
inputs in the IED. To do this PCM600 must be used.
The external control signals are used for activating a suitable setting group when
adaptive functionality is necessary. Input signals that should activate setting groups
must be either permanent or a pulse exceeding 400 ms.
Type Description
BOOLEAN Setting group 1 is active
BOOLEAN Setting group 2 is active
BOOLEAN Setting group 3 is active
BOOLEAN Setting group 4 is active
BOOLEAN Setting group 5 is active
BOOLEAN Setting group 6 is active
BOOLEAN Pulse when setting changed
BOOLEAN Settings over IEC 61850 enabled
Step Default
- SettingGroup1
1 1
Section 19
Basic IED functions
PID-6558-OUTPUTSIGNALS v6
Description
Active setting group
Max number of setting groups 1-6
IP11026-1 v2
PID-3572-SETTINGS v5
M12008-6 v3
M12008-8 v11
811