Settings - ABB REL650 Technical Manual

1MRK 506 382-UEN A
17.8.14.5
Table 554: I103POSCMD Non group settings (basic)
Name Values (Range)
FunctionType
InfNo
17.8.15
17.8.15.1
17.8.15.2
Line distance protection REL650 2.2 IEC
Technical manual

Settings

Unit
1 - 255 -
160 - 236 -
IED commands with position for IEC 60870-5-103
I103POSCMDV
Functionality
I103POSCMDV is a transceiver function that monitors activity on its input signals
and interprets any state transition into commands sent over an established IEC
60870-5-103 link. Additionally, it listens for general interrogation (GI) requests,
and replies to those with a GI response message with the current state of each
connected input.
Input POSITION is a double-indication signal, and it is GI enabled. This means
that any state transition, that is to ON, OFF, intermediate and faulty, is reported
spontaneously. However, the intermediate and faulty states may be suppressed by
setting the Report Intermediate Position = Off. See the settings for RS485 and
optical serial communication for more information.
When input BLOCK is ON, the function ignores GI requests and ceases all
monitoring activity. Consequently, no transitions will be detected.
The I103POSCMDV function is also equipped with two additional commands:
Operate and Cancel. These are hidden in ACT and respond only to base INF +2
and +3 respectively. The base INF (Information Number) parameter is an IEC
60870-5-103 identifier that associates a function in a 103 Master (such as Scada)
with its equivalent in the IED.
Identification
Function description
IED direct commands with position for
IEC 60870-5-103
Step Default
1 1
4 160
Function block
name
I103POSCMDV
Section 17
Station communication
Description
Function type
Information number for command output
GUID-CF04D9AC-40BE-46A3-A418-77204D2B0F27 v2
GUID-2249B679-03E4-43CC-B690-916246FE6A31 v1
IEC 60617 ANSI/IEEE C37.2
identification device number
- -
PID-6997-SETTINGS v1
759