Operation Principle; Single Command, 16 Signals Singlecmd; Identification; Functionality - ABB REL650 Technical Manual

1MRK 506 382-UEN A
11.9.6
11.10
11.10.1
11.10.2
Line distance protection REL650 2.2 IEC
Technical manual

Operation principle

AutomationBits function (AUTOBITS) has 32 individual outputs which each can
be mapped as a Binary Output point in DNP3. The output is operated by a "Object
12" in DNP3. This object contains parameters for control-code, count, on-time and
off-time. To operate an AUTOBITS output point, send a control-code of latch-On,
latch-Off, pulse-On, pulse-Off, Trip or Close. The remaining parameters will be
regarded were appropriate. ex: pulse-On, on-time=100, off-time=300, count=5
would give 5 positive 100 ms pulses, 300 ms apart.
There is a BLOCK input signal, which will disable the operation of the function, in
the same way the setting Operation: On/Off does. That means that, upon activation
of the BLOCK input, all 32 CMDBITxx outputs will be set to 0. The BLOCK acts
like an overriding, the function still receives data from the DNP3 master. Upon
deactivation of BLOCK, all the 32 CMDBITxx outputs will be set by the DNP3
master again, momentarily. For AUTOBITS , the PSTO input determines the
operator place. The command can be written to the block while in "Remote". If
PSTO is in "Local" then no change is applied to the outputs.

Single command, 16 signals SINGLECMD

Identification

Function description
Single command, 16 signals

Functionality

The IEDs can receive commands either from a substation automation system or
from the local HMI. The command function block has outputs that can be used, for
example, to control high voltage apparatuses or for other user defined functionality.
IEC 61850 IEC 60617
identification identification
SINGLECMD -
Section 11
Control
SEMOD158597-4 v5
SEMOD119849-1 v2
GUID-2217CCC2-5581-407F-A4BC-266CD6808984 v1
ANSI/IEEE C37.2
device number
-
M12446-6 v5
429