Communication Ports - ABB REL650 Technical Manual

Section 17
Station communication
17.8.16.2
770
10 Generic data
11 Generic identification
23 List of recorded disturbances
26 Ready for transm. of disturbance data
27 Ready for transm. of a channel
28 Ready for transm of tags
29 Transmission of tags
30 Transmission fo disturbance data
31 End of transmission
Selection of standard ASDUs in control direction
ASDU
6 Time synchronization
7 General interrogation
10 Generic data
20 General command
21 Generic command
24 Order for disturbance data transmission
25 Acknowledgement for distance data transmission
Selection of basic application functions
Test mode
Blocking of monitoring direction
Disturbance data
Private data
Generic services

Communication ports

The serial communication module (SLM) is used for SPA/IEC 60870-5-103/DNP
and LON communication. This module is a mezzanine module, and is placed
assembled on the Numerical module (NUM). The serial communication module
can have connectors for two plastic fibre cables (snap-in) or two glass fibre cables
(ST, bayonet) or a combination of plastic and glass fibre. Three different types are
available depending on type of fibre.
The incoming optical fibre is connected to the RX receiver input, and the outgoing
optical fibre to the TX transmitter output. When the fibre optic cables are laid out,
pay special attention to the instructions concerning the handling and connection of
the optical fibres. The module is identified with a number on the label on the
module.
1MRK 506 382-UEN A
Supported
No
No
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
No
Yes
Yes
Yes
Yes
No
Yes
Yes
Yes
No
Line distance protection REL650 2.2 IEC
Technical manual
M11874-626 v3