Panasonic KX-T336 System Reference Manual page 919

Assigning Items
Basic Shelf BS (Basic Slot) (02)
Expansion Shelf 1 FS (01 to 15)
Expansion Shelf 2 FS (01 to 15)
Description of Assigning Items
Basic Shelf FS (01 to 12)
Basic Shelf BS (02)
Expansion Shelf 1 FS (01 to 15)
Expansion Shelf 2 FS (01 to 15)
Conditions
The cursor does not move to BS01 and BS03. In BS02, assignable value is OHCA or Blank.
T-1/E-1 card should be assigned to FS01, 05 or 09 of any shelf.
One T-1 card occupies three slots. If you assign a T-1 card to FS01, FS02 and FS03 are not available for
other cards. A '– (hyphen)' is displayed in these two slots and the cursor skips them.
One E-1 card occupies four slots. If you assign an E-1 card to FS01, FS02 through FS04 are not available
for other cards. A '– (hyphen)' is displayed in these three slots and cursor skips them.
If no CO trunk card is assigned, "Trunk-CO Line" screen cannot be selected.
If no Extension card is assigned, "Extension-Station" screen cannot be selected.
If AGC card is not assigned, "Trunk-AGC" screen cannot be selected.
If DPH card is not assigned, "Extension-Doorphone" screen cannot be selected.
If ATLC card is not assigned, "Extension-Attendant Console" screen cannot be selected.
If DISA card is not assigned, "Special Attended-DISA" screen cannot be selected.
If DID card is not assigned, "Special Attended-DID" screen cannot be selected.
When assigning a card, the card status is Out of Service (OUS). When utilizing the card, the card status
should be set to In Service (INS).
For In Service (INS) and Out of Service (OUS), refer to Section 7-J-4.00 "INS (In Service)" and Section 7-
J-5.00 "OUS (Out of Service)."
For confirming whether the card status is INS or OUS, refer to Section 14-G-3.02 "Card Status screen."
When deleting (selecting blank) or changing the pre-assigned card type, the conditions should be the
followings:
• The card status is OUS or Fault.
Default
Automatic set
Blank : Not assigned
OHCA : T-SW Off-Hook Call Announcement
card
Automatic set
Same as Basic Shelf FS
Automatic set Same as Basic Shelf FS
Defines the type of card installed in the free slots (01 to 12) of the
basic shelf.
Used to utilize the T-SW OHCA card or not.
Defines the type of card installed in the free slots (01 to 15) of the
expansion shelf 1.
Defines the type of card installed in the free slots (01 to 15) of the
expansion shelf 2.
• All of the port data has been deleted.
9-C-4
(70695)
Selection of Value
Continued
Reference
1-A-5.00
1-E-1.00
to 2.00
1-E-7.00
to 21.00