Panasonic KX-T336 System Reference Manual page 937

Description of Assigning Items
Operator 1
Operator 2
Night Service
Auto Start Time
: MON. ( Day, Night)
: TUE. ( Day, Night)
: WED. ( Day, Night)
: THU. ( Day, Night)
: FRI. ( Day, Night)
: SAT. ( Day, Night)
: SUN. ( Day, Night)
PITS Programming
Password
Walking COS Password
Conditions
Operator 1
Operator 2
To select this screen, press the NEXT key in the "System-Operation (2/3)" screen.
Function
The following functions appear on the function line of this setting screen.
1 COMMON 2
COMMON (SHOW LV, CHG LV, INS, OUS, REMOVE, EXIT) and HRD CPY keys
are available in this setting screen.
For operation, refer to Section 7–I "Operation of Function Keys."
Assigns the terminal device for operator 1.
If selecting "EXT" for the terminal type, be sure to assign the directory
number beforehand.
Same as Operator 1.
If this is set to "Manual," the operator 1 must dial the feature number for
"Night Mode Set" for night service or "Night Mode Cancel" for day service.
If this is set to "Auto," the system will switch the day and night modes at
the programmed time each day. The operator 1, however, can override
the auto setting by dialing the feature number for "Night Service Manual
Mode Set." To restore the auto mode, the operator 1 must dial the feature
number for "Night Service Manual Mode Cancel."
Assigns automatic change-over time for each day of the week for
Day/Night Service.
Assigns the password for PITS system programming. This password is
used when a PITS allowed to program by COS wishes to change PITS
system programming or an Attendant Console wishes to perform CO
verify.
Assigns the password for Walking COS. Walking COS allows a user to
temporarily change the COS of another extension to that of the user's
extension. This is generally used for making toll calls from a toll restricted
telephone.
This system can accommodate up to two Attendant Consoles.
When Tenant Service is employed and if two Attendant Consoles are
assigned to tenant 1, no Attendant Console operator can be assigned to
tenant 2.
If only one Attendant Console is accommodated, it must be always
assigned to Operator 1.
3 4 5 6 HRD CPY 7
9-D-13
8