Panasonic KX-T336 System Reference Manual page 557

<Example>
Executing once at 10:15 a.m.:
Alarm 10:15 AM
Executing every day at 10:15 a.m.:
Alarm 10:15 AM*
7. Replace the handset or press the
SP-PHONE button.
Canceling the alarm time programmed
1. Lift the handset or press the SP-
PHONE button.
2. Dial the feature number for Timed
Reminder Cancel "#5" (default).
• You hear confirmation tone 1 or
2 and then dial tone 1 or 3 or 4.
• If your PITS has a display, it
shows:
Alarm Cancelled
3. Replace the handset or press the
SP-PHONE button.
Confirming the alarm time programmed (PITS with
display only)
1. Lift the handset or press the SP-
PHONE button.
2. Dial the feature number for Timed
Reminder Confirm "* 50" (default).
• The display on your PITS
shows:
When no time is set:
Alarm Not Stored
If executing every day at 9:00 a.m.
is preset:
<Example>
3. Replace the handset or press the
SP-PHONE button.
(Supplement)
When a user executes step 2 by a PITS set
without display, reorder tone is heard.
To stop the ringing of alarm tone
When the preset time comes, alarm tone sounds.
If your PITS has a display, it shows:
<Example>
1. Lift the handset or press the SP-
PHONE button.
• Alarm tone stops and you hear a
wake-up message or BGM, or
2. Replace the handset or press the
SP-PHONE button.
* This is determined by the system programming.
Refer to Section 3-F-13-00 "Timed Reminder
with OGM (Wake-up Call)."
(Supplement)
In step 1, if you press any button (including dial
keypad) except SP-PHONE without going off-
hook, alarm tone stops and then no tone sounds.
Dial tone 2 in step 1 sounds in the following timing:
1.0 sec
4-I-8
(40993)
Alarm 9:00 AM *
Alarm 5:00 PM
"intermittent tone" (dial tone 2).*