Panasonic KX-T336 System Reference Manual page 1174

Item
Assigning Items
Number
08
% Break
09
CPC Detection
10
Start Arrangement
11
Wink Signal Time-Out
Conditions
Before setting this screen, "Trunk Group (TG1) (TG2)" must be programmed.
This cannot be programmed if no CO trunk card is assigned in
"Slot Assignment (SLA)." If any one of the cards is programmed, this screen can
be programmed.
If the "Trunk Group (TG1)" containing the CO line has "Type" assigned to "6 (DID),"
or "7 (TIE)" the following items cannot be entered : " *** " is displayed :
• Direct Termination
• Night Answer Point (Type : No)
• CPC Detection
If the "Trunk Group (TG1)" containing the CO line has "Type" assigned to anything other than "6 (DID)," or
"7 (TIE)", the following items cannot be entered : " *** " is displayed :
• Start Arrangement
Item
Number
Direct Termination
03
Night Answer
04
Point (Type : No.)
Dial Type
05
1 : 60% break
2 : 67% break
(Not assignable when the dial type is DTMF)
00 : none
01 : 6.5 ms detection
02 to 75 : 8N ms detection
(Not assignable when the Trunk Group type is DID or TIE)
1 : immediate start
2 : delayed wink start
(Assignable when the Trunk Group type is DID or TIE)
1 : 64 ms
2 : 128 ms
•
•
•
127 : 8.128 s
• Wink Signal Time-Out
This is assignable only when the "Trunk Group (TG1)" containing the CO
line has "Incoming Mode (Day)" assigned to "2 (DIL 1:1)." Otherwise, "
is displayed and setting is impossible.
This is assignable only when the "Trunk Group (TG1)" containing the CO
line has "Incoming Mode (Night)" assigned to "2 (Fixed)" or "3 (Flexible)."
***
Otherwise, " " is displayed and setting is impossible.
"N (NAG)" can be selected only when Trunk Group "Incoming Mode (Night)"
is assigned to "2 (Fixed)."
If "Pulse mode" is selected, refer to Section 10-C-51.00 "World Select 1
(WS1)" about the following items:
• Interdigit Pause
• Pulse Type
• % Break Detect
10-C-35
(70695)
Input Value
Continued
*** "