Panasonic KX-T336 System Reference Manual page 1125

3.00 Other Error Messages
Error Message
Illegal parameter Unacceptable value is assigned.
Parameter is not Space exists between items.
consecutive
This parameter Assigned selection value is not for the item.
cannot assign
Duplicate parameter The number which is set previously in this
definition internal screen is assigned again.
Duplicate parameter The number which is set previously in a different
definition external screen is assigned.
Not installed Device is not installed.
Invalid status Status of the specified device does not accept
this command.
Diagnostic failure Diagnostic error is checked when In-Service
command is executed.
Insufficient privilege Privilege level is lower than specified level.
Failure Port test is made during a card malfunction.
Service violation Specified service is not executed.
Already accessed Another maintenance device (remote, PITS,
by another device system) is in use.
Printer is not ready Printer is not connected to the system or the
power is off.
Cannot print out in Print out is unavailable from Remote.
remote
Waiting Changing of program data is suspended
because call placement is going on.
Calender IC trouble Calendar IC malfunction.
Device error Backup device is not connected (only when
maintenance device is ATT).
Version error Different version at the time of backup.
Checksum error A checksum error has been detected.
Probable Cause
9-M-7
(70695)
Countermeasure
Assign an allowable value.
Remove the space.
Set the assignable value.
Set the number different from the previous
number.
Set the number different from the previous
number.
Assign the installed device.
Change the status of the device to be
acceptable for the command.
Execute test.
Increase the privilege level through the
Change level function.
Repair the malfunctioning card.
Check specified service.
Wait until another device is finished or let him
finish.
Connect the printer, and make the power on.
Execute print out on-site.
Wait for a while or cancel the setting by
"CTRL+C"
Repair calender IC.
Connect the backup device to SIO # 1 Port.
Match the backup version.
Communication line is defective, or backup
data is destroyed.