Serial Call - Panasonic KX-T336 System Reference Manual

3.00 Serial Call

Description
Allows the attendant to transfer a CO call to
multiple extensions (up to three extensions)
sequentially.
When the first extension hangs up, a call is
transferred to the second extension and the third
extension in sequence automatically without
assistance of the attendant console.
For this function prior assigning of SERIAL key to
a programmable key is necessary.
Programming
Attendant Management
SERIAL key
Conditions
In case the specified extension is busy or does
not answer within specified duration, call
advances to the next extension.
Specified duration is the preset time assigned in
"Call Forwarding No-Answer Time-Out" by system
programming.
If all of the called extensions answer, serial call is
concluded. If any of the called extensions is busy
or does not answer, calling the attendant console
starts again automatically.
Operation
CO call arrives at attendant console.
ANSWER
SERIAL
Reference
6-C-10.00
RELEASE
Making a CO outgoing call and transfer it to
extensions
LOOP
6-G-7
1. Answer the call by pressing the
ANSWER key (programmable
key).
• SRC indicator lights.
Start conversation.
2. Press the SERIAL key
(programmable key).
• Outside party is placed on
hold, SRC indicator starts to
flash in 60 winks.
• DES indicator lights.
3. Dial the required extension
number.
4. Repeat steps 2 and 3 for each
required extension (up to three)
during silence.
5. Press the RELEASE key.
• The SRC and DES indicator
lights go out.
1. Press an idle LOOP key.
2. Make an outgoing CO call.
Steps 3 to 5 are same as
mentioned above.