Panasonic KX-T336 System Reference Manual page 685

Functions of various keys on the function keyboard
Function keys : Functions of these keys vary according to the displayed screen.
(F1 to F8)
LOOP keys : Used to make and answer the calls (both extension and outside) etc..
(LOOP1 to
LOOP6)
RELEASE key : Releases a call held on the LOOP key.
ANSWER key : Used to answer incoming calls in first come first served basis.
HOLD key : Places a call on hold.
CANCEL key : Cancels any key operation while holding a call on the LOOP key.
SPLIT key : Switches between the SRC (Source) side party and DES (Destination) side party.
PAGE key : Used to execute parking a call and paging functions.
ALARM key : Displays major/minor alarm when the ALARM LED is flashing/lit.
NIGHT key : Switches between day and night modes.
MSG key : Used to leave a message on the LED of an extension which does not answer.
DIAL PAD : Used to dial the telephone number and the feature number.
(0 to 9, #)
Programmable There are 12 programmable keys on the keyboard, which can be assigned to be any
keys: of 11 function keys listed below:
Refer to 6-C-10.00 "Attendant Management Screen," for further information about
Programmable key.
• The attendant console is operable as call processing terminal and system
PRG MODE
administration terminal by setting this switch ON and OFF.
switch :
• When you set this switch to ON, the initial display of VT programming mode appears
on the screen.
Now you can operate the attendant console as the system administration device.
(System administration device name must be set to "ATT 1 or ATT 2" in the system
programming beforehand.)
• You can enter into Dumb programming mode by pressing CTRL key + V key
simultaneously at main menu screen of VT programming mode.
• Set this switch to OFF, to return to the call processing mode.
AUTO, TRG, CALL-PARK, TOLL-CHG, ACCOUNT, SERIAL,
OHCA, CONF, REDIAL, E-E and One Touch (direct input)
6-A-3