Panasonic KX-T336 System Reference Manual page 933

Description of Assigning Items
System Administration
Device
SMDR
Page Length (4~99)
Skip Perf (0~95)
Outgoing Duration Log
Incoming Duration Log
Attendant Duration
Special Carrier Name
Print Secret Dial
Error Log /Programming/ Determines if error logs will be printed out.
Traffic
Start Time of Traffic
Measurement
Start Time of Test
Remote Directory Number
Remote Alarm
Destination Address
Assigns the terminal device to be used for setting system administration
data.
Enables or disables SMDR ( Station Message Detail Recording).
Assigns the printer page length (number of lines).
Determines the number of lines to be skipped and the number of lines to be
printed on each page. The number of lines to skip is simply the number
specified in this parameter. The number of lines printed is the difference
between the page length number and the skip perforation number.
If system data is being printed the difference must be equal to or greater
than 23 to allow one full screen to be printed on each page. If SMDR data
is being printed the difference must be equal to or greater than six to allow
the header and at least one line of SMDR data to be printed.
Determines which types of outgoing calls will be printed, if any.
Note:
"Toll Only" is not available from software version 9.5X or higher in all areas.
Determines if incoming calls will be printed or not.
Determines whether the attendant or the destination will be charged with
the time for an attendant handled call. If "Separate" is selected, there will be
two lines of SMDR for every attendant handled and transferred call.
Assigns the special carrier name type to be printed out.
Determines if secret dial numbers will be printed out.
Determines if programming data is printed out.
Determines if traffic measurement data is printed out.
Assigns the starting time for traffic measurement.
Assigns starting time of the self- test. The system must be idle
for the test to be performed.
Assigns a floating directory number for the remote maintenance port.
If "RMT" is not preset in the "Configuration-Slot Assignment" screen, the
default value is blank.
If this option is enabled alarms will be automatically sent to the telephone
number in the destination address.
The destination telephone number for remote alarms.
9-D-9
(70695) (60395)