Panasonic KX-T336 System Reference Manual page 1250

To change the default setting
(Deactivating the polarity reversal detection)
1. At the programming prompt (PRG>), type:
; PRG> PRD AT
The screen displays the input prompt (INPUT >>) as follows:
; PRG> PRD AT
; Equipment No.2011.................Y
; INPUT >>
2. At input prompt (INPUT >>), type:
; PRG> PRD AT
; Equipment No.2011.................Y
; INPUT >> N
The screen displays the next input prompt (INPUT >>) as follows:
; PRG> PRD AT
; Equipment No.2011.................Y
; INPUT >> N
; Equipment No.2012.................Y
; INPUT >>
3. Follow the step 2 for other CO line ports of an R-LCOT card.
4. To store the new assignments to the system,
at input prompt (INPUT >>), type:
; PRG> PRD AT
; Equipment No.2011.................Y
; INPUT >> N
; Equipment No.2012.................Y
; INPUT >> N
; Equipment No.2018.................Y
; INPUT >> N
; Equipment No.2011.................N
INPUT >> $ EOD
This assigns the new setting to the system, and the programming prompt
(PRG >) appears again.
To finish the programming
At the programming prompt (PRG >), type:
( ↵ )
; PRG> EXIT
The screen displays the initial prompt ( > ) of the Dumb programming
mode as follows:
; PRG> EXIT
; >
( ↵ )
( ↵ )
( ↵ )
10-C-101
(30393)