Panasonic KX-T336 System Reference Manual page 1216

51.00 World Select 1 (WS1)
Description
"WS1" command provides the following assignments.
(Password level: Two or higher)
(1) Interdigit Pause (For Dial Pulse Trunk)
Interdigit Pause is used to distinguish between pulse signals. To meet the requirements of your
central office, select the appropriate value that represents the delay between dial pulses.This setting
is only required when using dial pulse trunks.
(2) Pulse Type (For Dial Pulse Trunk)
The system supports the following three types of dial pulse signaling. Select the appropriate option to
your area.This setting is only required when using dial pulse trunks.
(3) Automatic Redial Retry Count
Used to set the number of times Automatic Redial is tried. Automatic redialing of the last dialed
number is done up to the specified number of times.
(4) Automatic Redial Retry Interval
Used to set the interval time between Automatic Redial attempts.Refer to Section 4-C-4.04 "Automatic
Redial" for further information.
(5) % Break Detect (SLT)
Dialed digits from dial pulse type Single Line Telephone (SLT) is transmitted to the system by making
and breaking a loop current (dc path), thereby interrupting loop current.Duration time required to
detect the number of breaks depends on the SLT connected and can be administered to "16 to 96 ms"
or "16 to 136 ms" by this command.
(6) Flash Detect (SLT)
It is assignable that the Flash signal transmitted from SLT is detected or not by the system.If "0=No" is
selected, the system does not detect the Flash signal transmitted from SLT.
(7) Flash Detect (TIE)
Assigns the length of the flash time which applies to calls on TIE trunks.
This is the time the system needs to detect the flash signal sent from the other PBX of a TIE Line
Network. Duration time required is determined by the other PBXs.
(8) Answer Decision Timer
This entry applies to calls on TIE trunks.
This is the time the system needs to recognize the off-hook signal sent from the other PBX before
connecting the voice path.
The entry is entered in 32 ms increments.
Input Format
Mode (SH/AT/BT)
W S 1
Index Number
None
Item Number (1-8) CR
10-C-77
(70695)