Help - Agilent Technologies 1260Infinity II Bio-inert FractionCollector User Manual

Help:

Start
The Start page of the Delay Calibration Wizard contains a description of the
fraction collector delay calibration process, together with a schematic diagram
of the connections for the detector and fraction collector.
Cancel
Next
Set Up Calibration
The Set Up Calibration page of the Delay Calibration Wizard performs three steps to
prepare for the delay calibration:
1 Instrument Check
2 Fraction Collector Module Selection
3 Module Connection Verification
Back
Cancel
Next
1260 Infinity II Analytical-Scale & Bio-inert Fraction Collector User Manual
The system checks that the instrument is ready for calibration. If the
instrument check fails, an error is displayed and the delay calibration is not
possible until the error has been cleared.
If you have only one fraction collector configured, its module type ID and
serial number are displayed in the field. If you have configured a fraction
collector cluster, click the down arrow and select the fraction collector from
the drop-down list.
A connection to the selected module is established, and all required
parameters are read from the module. The identities of the Linked Pump and
Peak Detectors are shown (module type ID and serial number); for the peak
detectors, the currently stored delay volumes are also shown.
An error is displayed if the selected module does not support Delay Calibration.
Configuration and Operation of the Fraction Collector
Closes the Delay Calibration Wizard without consequence.
Displays the Set Up Calibration page of the Delay Calibration
Wizard ("Set Up Calibration"
Displays the Start page of the Delay Calibration Wizard
("Start" on page 35).
Closes the Delay Calibration Wizard without consequence.
Displays the Prepare Instrument for Calibration page of the Delay
Calibration Wizard ("Prepare Instrument for Calibration"
page 36).
This button is active only when a fraction collector has been
selected.
Using the Module
on page 35).
3
on
35