14/LIGHT SYSTEM, INSTRUMENTS
Changing the low beam bulb
17.19
Note
Damage to reflector Reduced luminance.
–
Grease on the bulb will evaporate due to the heat and be deposited on the reflector. Clean the bulb and keep it free of grease
before mounting.
–
Position the lug
–
Check that the lighting is functioning properly.
400422-12
–
Position the cover.
Info
Check for correct positioning and freedom of movement of the brake lines.
–
Mount and tighten screws
Guideline
Remaining chassis screws
100745-12
–
Switch off all power consumers and the engine.
–
Fold up the combination instrument. Pull the lug
–
Remove the rubber retainer.
100742-10
–
Release the latch
–
Remove the lamp cover
100743-10
of the lamp cover in the notch. Engage the latch.
.
M6
.
.
10 Nm (7.4 lbf ft)
out of the rubber retainer
112
.