KTM 1190 RC8 R EU/UK 2009 Repair Manual page 391
Hide thumbs
Also See for 1190 RC8 R EU/UK 2009:
- Owner's manual (283 pages) ,
- Owner's manual (242 pages) ,
- Owner's manual (273 pages)
Table of Contents
Advertisement
ENGINE CONTROL TROUBLE CODE
–
Check the cable from connector AT (
to plus (terminal 30).
–
Check the cable from connector AP (
to plus (terminal 30).
–
Check the cable from connector CU (
cuit to plus (terminal 30).
»
If the specifications have been met:
–
Check the next possible cause:
CAN-low - the signal wire has a short circuit to the sensor power supply (
CAN-low - the signal wire has a short circuit to the sensor power supply
Condition
The ignition is off.
The diagnostics tool is disconnected.
The EFI control unit is disconnected. (
The break out box is connected to the wiring harness.
The CAN bus terminating resistor is disconnected. (
The immobilizer control unit is disconnected. (
The instrument panel is disconnected.
CAN-low - check the signal wire for a short circuit to the sensor power supply
–
Measure the resistance between the specified points.
Break out box CO pin 20 – Break Out Box AO pin 1
Resistance
»
If the specifications have not been met:
–
Check the cable from connector EV (
to plus (terminal 30).
–
Check the cable from connector DO (
to plus (terminal 30).
–
Check the cable from connector AT (
to plus (terminal 30).
–
Check the cable from connector AP (
to plus (terminal 30).
–
Check the cable from connector CU (
cuit to plus (terminal 30).
»
If the specifications have been met:
–
Check the next possible cause:
CAN bus terminating resistor - value not plausible (
CAN bus terminating resistor - value not plausible
p. 395) pin 2 to the EFI control unit connector CO (
p. 393) pin 2 to the EFI control unit connector CO (
p. 398) pin 3 to the EFI control unit connector CO (
p. 227)
p. 404)
p. 102)
600850-12
p. 403) pin 5 to the EFI control unit connector CO (
p. 400) pin 8 to the EFI control unit connector CO (
p. 395) pin 1 to the EFI control unit connector CO (
p. 393) pin 3 to the EFI control unit connector CO (
p. 398) pin 4 to the EFI control unit connector CO (
p. 389)
Condition
The ignition is off.
The CAN bus terminating resistor is disconnected. (
p. 389)
600850-11
∞ Ω
p. 397) pin 19 for a short circuit
p. 397) pin 19 for a short circuit
p. 397) pin 19 for a short cir-
p. 397) pin 20 for a short circuit
p. 397) pin 20 for a short circuit
p. 397) pin 20 for a short circuit
p. 397) pin 20 for a short circuit
p. 397) pin 20 for a short cir-
p. 404)
389
Advertisement
Table of Contents
