Adjusting The Position Of The Throttle Position Sensor In Circuit A - KTM 1190 RC8 R EU/UK 2009 Repair Manual

41/THROTTLE VALVE BODY

Adjusting the position of the throttle position sensor in circuit A

29.3
Condition
The ignition is on.
The diagnostic tool is connected and running.
–
Remove the throttle valve body to adjust. (
–
Select the model.
–
Select "ECU Diagnosis".
–
Mark the "Engine management EFI LC8 RC8" control unit.
–
Press "Continue".
–
Select "Adjustment".
–
"Please enter the password:"
–
Press "Continue".
–
Select "Throttle position sensor circuit A adjustment".
–
Press "Continue".
–
Read the information page on the KTM diagnostics tool and using "Continue" start the calibration process.
Info
The motor drive moves the throttle valve in circuit A to the "zero" position (throttle valve fully closed position).
Throttle position sensor circuit A voltage "(THAD)"
In "zero" position
» If the displayed value does not correspond to the nominal value:
–
Loosen screw .

–
Turn the throttle position sensor to adjust it to the specified value.
Guideline
Throttle position sensor circuit A voltage "(THAD)"
In "zero" position
–
Tighten screw .

–
Open and close the throttle grip fully ten times.
–
Check the voltage again and readjust if necessary.
–
Reinstall the throttle valve body when the adjustments have been made. (
p. 221)
0.56... 0.64 V
0.56... 0.64 V
400680-10
p. 222)
220