ENGINE CONTROL TROUBLE CODE
Ignition coil cylinder 2 - the power supply is interrupted
Condition
The ignition is on.
The diagnostics tool is connected and active.
EFI control unit is connected. (
Ignition coil cylinder 2 is disconnected. (
Ignition coil cylinder 2 - check the power supply
–
Measure the voltage between the specified points.
Ignition coil cylinder 2 connector AS pin 2 – Measuring point Ground (−)
Info
For measurement the measuring points must be subjected to a 12V/21W bulb load.
The value may not differ from the battery voltage "VBAT" by more than 1 V.
»
If the specifications have not been met:
–
Check connector AS pin 2.
–
Check the cable from connector AS pin 2 to the next node in the wiring harness for opens.
»
If the specifications have been met:
–
Contact customer service.
p. 227)
p. 218)
400644-10
400658-10
317