KTM 1190 RC8 R EU/UK 2009 Repair Manual page 280

ENGINE CONTROL TROUBLE CODE
Blink code EFI warning
lamp (MIL)
Display on diagnostic tool
Error level condition
Function check
Possible cause
Last measure if none of the doc-
umented causes leads to elimi-
nation of the fault
Lambda sensor cylinder 1 - checking the voltage
Condition
The engine is running at idle speed.
The diagnostic tool is connected and running.
The engine is at operating temperature.
–
Select the model.
–
Select "ECU Diagnosis".
–
Mark the "Engine management EFI LC8 RC8" control unit.
–
Press "Continue".
–
Select "Measured Values".
–
Mark "Lambda values".
–
Press "Continue".
–
Highlight "Lambda sensor cylinder 1 voltage (HEGO1AD)" and deselect the other parameters with "Select live data".
Lambda sensor
Lambda sensor cylinder 1 voltage "HEGO1AD"
» If the displayed value corresponds to the nominal value:
–
Delete trouble code.
–
Take a test ride.
–
Read out the trouble code memory using the KTM diagnostics tool.
» If the displayed value does not correspond to the nominal value:
–
Check the next possible cause:
Lambda sensor cylinder 1 - value not plausible (
Lambda sensor cylinder 1 - value not plausible
17 EFI warning lamp (MIL) flashes 1x long, 7x short
P0130
"Lambda sensor cylinder 1, sensor 1"
"Circuit fault"
Circuit fault: ≥ 60 s
Lambda sensor cylinder 1 - checking the voltage (
Lambda sensor cylinder 1 - value not plausible (
Lambda sensor heater cylinder 1 - the signal wire has a short circuit to ground (terminal 31)
( p. 279)
Lambda sensor cylinder 1 - the signal wire has a short circuit to sensor ground (
Lambda sensor cylinder 1 - the signal wire has a short circuit to plus (terminal 30) (
Lambda sensor cylinder 1 - the signal wire has a short circuit to ignition plus (terminal 15)
( p. 280)
Lambda sensor cylinder 1 - the signal wire has a short circuit to the sensor power supply
( p. 280)
Lambda sensor cylinder 1 - the signal wire has an open (
Lambda sensor cylinder 1 - the ground wire has an open (
–
Contact customer service.
p. 278)
Condition
The ignition is on.
The engine is running at idle speed.
The engine is at operating temperature.
Lambda sensor for cylinder 1 is connected. (
p. 278)
p. 278)
p. 281)
p. 281)
0.2... 0.8 V
p. 62)
278
p. 279)
p. 280)