KTM 1190 RC8 R EU/UK 2009 Repair Manual page 312

ENGINE CONTROL TROUBLE CODE
Ignition coil cylinder 1 - check the control wire for a short circuit to sensor ground.
–
Measure the resistance between the specified points.
Break out box CO pin 29 – Break Out Box AO pin 7
Resistance
» If the specifications have not been met:
–
Check the cable from EFI control unit connector CO (
sensor ground.
» If the specifications have been met:
–
Check the next possible cause:
Ignition coil cylinder 1 - the control wire has a short circuit to plus (terminal 30) (
Ignition coil cylinder 1 - the control wire has a short circuit to plus (terminal 30)
Condition
The ignition is off.
The EFI control unit is disconnected. (
The break out box is connected to the wiring harness.
Ignition coil cylinder 1 is disconnected. (
Ignition coil cylinder 1 - check the control wire for a short circuit to plus (terminal 30).
–
Measure the voltage between the specified points.
Break out box CO pin 29 – Measuring point Ground (−)
Voltage
» If the specifications have not been met:
–
Check the cable from EFI control unit connector CO (
plus (terminal 30).
» If the specifications have been met:
–
Check the next possible cause:
Ignition coil cylinder 1 - the control wire has a short circuit to ignition plus (terminal 15) (
Ignition coil cylinder 1 - the control wire has a short circuit to ignition plus (terminal 15)
Condition
The ignition is off.
The EFI control unit is disconnected. (
The break out box is connected to the wiring harness.
Ignition coil cylinder 1 is disconnected. (
600850-12
p. 227)
p. 218)
600850-12
p. 227)
p. 218)
600850-11
∞ Ω
p. 397) pin 29 to connector AS (
400658-10
< 0.1 V
p. 397) pin 29 to connector AS (
p. 394) pin 1 for a short circuit to
p. 310)
p. 394) pin 1 for a short circuit to
p. 310)
310