Checking The Fuel Pressure During The Actuator Test - KTM 1190 RC8 R EU/UK 2009 Repair Manual

07/FUEL TANK, SEAT, TRIM

Checking the fuel pressure during the actuator test

11.10
Danger
Fire hazard Fuel is highly flammable.
–
Never fill up the vehicle near open flames or burning cigarettes, and always switch off the engine first. Be careful that no
fuel is spilt, especially on hot vehicle components. Clean up spilt fuel immediately.
–
Fuel in the fuel tank expands when warm and can escape if the tank is overfilled. See specifications on filling up with fuel.
Warning
Danger of poisoning Fuel is poisonous and a health hazard.
–
Avoid contact between fuel and skin, eyes and clothing. Do not inhale fuel vapors. If fuel gets into your eyes, rinse immedi-
ately with water and contact a doctor. Wash affected skin areas immediately with soap and water. If fuel is swallowed, con-
tact a doctor immediately. Change clothing that has come into contact with fuel. Store fuel in a suitable canister according
to regulations and keep it out of the reach of children.
Warning
Danger of burns Some vehicle components get very hot when the machine
is driven.
–
Wear appropriate protective clothing and safety gloves. In case of burns,
rinse immediately with lukewarm water.
–
Remove the special tool.
–
Connect the fuel hose connection.
–
Press down the metal plate and disconnect the fuel hose connection
Info
Remaining fuel may run out of the fuel hose.
200559-01
–
Install the special tool.
Pressure testing tool (61029094000) (
–
Start the "Fuel pump relay operation" actuator test.
–
Check the fuel pressure.
Fuel pressure
When the fuel pump is active
» The specifications have not been met:
200560-01
–
Change the fuel filter.
–
Check that the fuel lines are free of blockages.
–
Change the fuel pump.
–
End the "Fuel pump relay operation" actuator test by pressing the "Quit" button.
–
Remove the special tool.
–
Connect the fuel hose connection.
.

p. 443)
3.3... 3.7 bar (48... 54 psi)
74