07/Fuel Tank, Seat, Trim; Removing The Seat; Fitting The Seat; Removing The Passenger Seat - KTM 1190 RC8 R EU/UK 2009 Repair Manual

07/FUEL TANK, SEAT, TRIM

Removing the seat

11.1

Fitting the seat

11.2

Removing the passenger seat

11.3

Mounting the passenger seat

11.4

Dismounting the fuel tank

11.5
Danger
Fire hazard Fuel is highly flammable.
–
Never fill up the vehicle near open flames or burning cigarettes, and always switch off the engine first. Be careful that no
fuel is spilt, especially on hot vehicle components. Clean up spilt fuel immediately.
–
Fuel in the fuel tank expands when warm and can escape if the tank is overfilled. See specifications on filling up with fuel.
–
Insert the ignition key in the seat lock
–
Raise the rear of the seat, push it towards the rear, and remove it upwards.
100669-10
–
Position the recesses of the seat to the lugs on the frame, lower the rear end and
simultaneously push it forward.
–
Lock the seat by turning the ignition key in the seat lock.
–
Remove the ignition key from the seat lock.
–
Finally, check that the seat is correctly mounted.
100730-10
–
Remove the seat. (
–
Activate the release lever
–
Take off the passenger seat
100731-10
Warning
Danger of accidents The passenger seat can come loose from the anchoring
if it is not mounted correctly.
–
After mounting the passenger seat, check that it is locked correctly by
pulling up on the supporting strap. There should be no play in the
unlocking lever.
–
Position the passenger seat in the space provided.
–
Press down the passenger seat until it clicks into place.
100732-01
–
Finally, check that the passenger seat is correctly mounted.
and turn it clockwise.

p. 70)
.

toward the top.

70