Activating The Icu - KTM 1190 RC8 R EU/UK 2009 Repair Manual

14/LIGHT SYSTEM, INSTRUMENTS

Activating the ICU

17.3
Info
To program the new imobilizer control unit, the two black ignition keys are needed.
–
Switch off the ignition by turning the black programming key to
the position OFF
–
Remove the black ignition key.
–
To activate further ignition keys, repeat the last 4 steps with the respective
ignition key.
–
Insert the orange programming key in the ignition lock.
–
Switch on the ignition by turning the orange programming key to the ON posi-
tion .
EFI warning lamp
The immobilizer indicator lamp
flashes according to the number of functioning black ignition keys includ-
ing the orange programming key.
–
Switch off the ignition by turning the orange programming key to the OFF posi-
tion .
–
Pull out the orange programming key.
All black ignition keys are activated included in this job sequence are acti-
vated.
–
Install the new imobilizer control unit.
–
Press the emergency OFF switch into the position
–
Insert the supplied orange programming key into the ignition lock.
–
Switch on the ignition by turning the orange programming key to the ON position
EFI warning lamp
The immobilizer indicator lamp
–
Switch off the ignition by turning the orange programming key to the OFF posi-
tion .
–
Pull out the orange programming key.
100749-01
–
Insert the first black ignition key into the ignition lock.
–
Switch on the ignition by turning the black programming key to the position ON
EFI warning lamp
The immobilizer
on again.
–
Switch off the ignition by turning the black programming key to the position OFF
–
Pull out the first black ignition key.
–
Insert the second black ignition key into the ignition lock.
–
Switch on the ignition by turning the black programming key to the position ON
EFI warning lamp
The immobilizer
on again.
–
Connect the diagnostic tool.
–
Start diagnostic software.
–
Select the model.
–
Select "ECU Diagnosis".
–
Mark the "Engine management EFI LC8 RC8" control unit.
–
Press "Continue".
–
Select "Coding".
–
"Please enter the password:"
900039-60
–
Press "Continue".
–
Select "Teach-in immobilizer control unit".
.
(MIL) lights up, switches off, and then starts to flash.
lights up, switches off briefly, and
(MIL) lights up, switches off, and then starts to flash.
lights up.
(MIL) lights up, switches off, and then starts to flash.
indicator lamp lights up, switches off briefly, and switches
(MIL) lights up, switches off, and then starts to flash.
indicator lamp lights up, switches off briefly, and switches
104
.
.
.
.
.