KTM 1190 RC8 R EU/UK 2009 Repair Manual page 290

ENGINE CONTROL TROUBLE CODE
Blink code EFI warning
lamp (MIL)
Display on diagnostic tool
Error level condition
Function check
Possible cause
Last measure if none of the doc-
umented causes leads to elimi-
nation of the fault
Injector cylinder 1 - checking the control
Condition
The ignition is on.
The diagnostic tool is connected and running.
–
Select the model.
–
Select "ECU Diagnosis".
–
Mark the "Engine management EFI LC8 RC8" control unit.
–
Press "Continue".
–
Select "Actuator Test".
–
"Please enter the password:"
–
Press "Continue".
–
Select "Injector cylinder 1".
–
Press "Continue".
–
In the KTM diagnostics tool, read the information page and start the actuator test with "Continue".
Injector
» If the specifications have been met:
–
Delete trouble code.
–
Take a test ride.
–
Read out the trouble code memory using the KTM diagnostics tool.
» The specifications have not been met:
–
Check the next possible cause:
Cylinder 1 injector - value not plausible (
Cylinder 1 injector - value not plausible
33 EFI warning lamp (MIL) flashes 3x long, 3x short
P0201
"Injector cylinder 1"
"Circuit fault"
Circuit fault: ≥ 0.5 s
Injector cylinder 1 - checking the control (
Cylinder 1 injector - value not plausible (
Injector cylinder 1 - there is a power supply fault (
Injector cylinder 1 - the control wire has a short circuit to plus (terminal 30) (
Injector cylinder 1 - the control wire has a short circuit to ignition plus (terminal 15) (
Injector cylinder 1 - the control wire has a short circuit to the sensor power supply (
Injector cylinder 1 - the control wire has an open. (
Injector cylinder 1 - the control wire has a short circuit to ground (terminal 31) (
Injector cylinder 1 - the control wire has a short circuit to sensor ground (
–
Contact customer service.
p. 288)
Condition
The ignition is off.
Injector cylinder 1 is disconnected. (
Cylinder 1 injector - check the resistance
–
Measure the resistance between the specified points.
Injector pin 1 – Injector pin 2
Injector
Resistance at: 20 °C (68 °F)
» If the specifications have not been met:
400598-10
p. 288)
p. 288)
p. 289)
p. 291)
Operating noise
p. 225)
10.5... 13.0 Ω
288
p. 289)
p. 290)
p. 290)
p. 291)
p. 292)