16
ELECTRICAL SYSTEM
16.9
Changing the low beam bulb
Note
Damage to reflector Reduced brightness.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease before
mounting.
–
Mount and tighten screws
Guideline
Remaining chassis screws
S00368-11
Finishing work
–
Install the wind shield. (
–
Install the mask spoiler.
–
Install the tank cover. (
–
Install the front side cover. (
–
Mount the driver's seat. (
–
Mount the passenger seat. (
–
Check the headlight setting. (
Preparatory work
–
Switch off all power consumers and switch off the engine.
.
2
M6
p. 124)
x
(
p. 117)
p. 122)
p. 113)
p. 101)
p. 100)
p. 168)
164
10 Nm (7.4 lbf ft)