Changing The Step Bearing Of The Crankshaft - KTM 1190 RC8 R EU/UK 2009 Repair Manual
Hide thumbs
Also See for 1190 RC8 R EU/UK 2009:
- Owner's manual (283 pages) ,
- Owner's manual (281 pages) ,
- Owner's manual (242 pages)
Table of Contents
Advertisement
30/ENGINE - WORK ON INDIVIDUAL PARTS
Changing the step bearing of the crankshaft
20.10
–
Press in outer shaft seal ring
–
Insert water pump cover
200456-10
–
Mark the position of the bearing joint
200459-10
–
Pull out the step bearing shells
Bearing puller (15112017000) (
Insert for bearing puller (60029018000) (
200460-10
–
Center the new main bearing shells
Step bearing tool (60029046028) (
200461-10
–
Support the clutch cover directly under the step bearing. Press in the step bearing
shells using the special tool until they are flush.
Step bearing tool (60029046028) (
200462-10
fully, with the open side flush and facing outwards.
.
.
using the special tool.
p. 440)
p. 441)
using the special tool.
p. 442)
p. 442)
146
Advertisement
Table of Contents
