Setting The Engine To Ignition Top Dead Center Of The Front Cylinder - KTM 1190 RC8 R EU/UK 2009 Repair Manual
Hide thumbs
Also See for 1190 RC8 R EU/UK 2009:
- Owner's manual (283 pages) ,
- Owner's manual (273 pages) ,
- Owner's manual (272 pages)
Table of Contents
Advertisement
30/ENGINE
Setting the engine to ignition top dead center of the front cylinder
18.5
–
Turn the crankshaft counterclockwise until markings
the cylinder head.
301441-10
–
Remove screw
–
Look through the hole to check that the position notch of the crankshaft is visible.
–
Screw in special tool
Engine blocking screw (61229015000) (
200540-11
Condition
The engine is positioned at ignition top dead center of the rear cylinder.
–
Loosen special tool
Engine blocking screw (61229015000) (
200544-10
–
Continue turning the crankshaft counterclockwise until markings
the edge of the cylinder head.
–
Screw special tool
301442-10
.
.
by several turns.
back in.
are flush with the edge of
p. 444)
p. 444)
are flush with
121
Advertisement
Table of Contents
